When the corn harvester is working, it is often encountered that the work of the harvesting machine is not smooth due to the blockage of the corn header. However, the harvester cannot be transported by the ear picking rollers after picking ears, which may cause the auger of the corn header to be blocked, which will lead to the unsmooth operation of the corn harvester. Therefore, the technical consultant of TAGRM will take you to understand the four major factors that affect the clogging of the corn header auger.
1. The auger blade of the corn header is deformed. When the corn header is working, if it encounters the deformation of the auger blade, it should be corrected in time, otherwise it will easily cause its conveying capacity to fail to keep up, which will affect the blockage of the corn header auger.
2. The gap between the corn header auger and the bottom of the header is large. If the gap between the two is too large, the transportation of the ear of corn is likely to be blocked, which will lead to the blockage of the auger.
3. Corn header auger turns incorrectly. When installing the header, pay attention to the drive chain of the auger. Its rotation direction affects whether the ears of corn will accumulate on both sides without entering the middle, which will cause the auger to be blocked.
4. The feeding amount of corn header is large. When the corn harvester works faster, the feeding amount of the header will also increase, which is easy to cause the transportation capacity of the auger to keep up, which in turn leads to the blockage of the auger.
